Everything For Your Miniatures

A portable grinder you can use to grind or engrave plastic parts conveniently. It can be set at any of three speeds and has an autonomy of approximately 1h between charge...

Acrylic paints are typically applied with brushes or with an airbrush. These solutions are fine, especially if you are going to apply paint on large surfaces, or spend several hours...

We are used to using all sorts of sanding mediums: sanding sticks, sandpaper, or sponges. The problem these have, however, is that it's very hard to use them if you...

Paints that are stored for a while may start hardening inside the bottle, as pigments deposit at the bottom. If you use paints that come in a bottle you can...

In some cases, pieces are attached to the sprues (or runners) with quite inaccessible connection points. If you use a traditional side-cutter, you may have a hard time reaching it,...

Please note that the sanding disks and connecting rods are sold separately, except for the combo package.  Convenient sanding disks and connecting rods that can be installed in any scale...

We often have to remove delicate pieces from the sprue (or runner, however you prefer to call them). Or cut pieces that have a very narrow connection point, that could...

Modelers often have to make precise and controlled cuts on their models. Maybe the instructions call for it, or maybe you want to install aftermarket parts. Regular hobby saws and...

One of the problems all of us that enjoy arts and crafts is working with these tiny parts, especially once our eyes don't work as well as when we were...

If a paint bottle has been on the shelf for a given time, or if you have mixed paints in a cup, paint flakes may appear. This is quite troublesome...

Many of us enjoy hobbies that require steady hands. However, stress, too much caffeine, or age can hinder our ability to keep our hands firm and steady. This can be...

We often have to carve or sand material from parts of our models, sculptures, or wood pieces that are very hard to reach with a regular file. Or from spots...